Bernina 8 SERIES V29.39.00 Uživatelský manuál

Information on Software Update BERNINA 8 Series, V29.39.00

3 EMBROIDERY UPDATES (BERNINA 830 ONLY)3.1 Start of embroideryIf the Start button was pressed while the bobbin door was open, either the embroidery st

3.4 Thread tension can be changed to a minimum of 0.5A new parameter controls the minimum thread tension range (between 0.0 - 1.0)In the embroidery mo

3.5 Stop for manual cutting can be switched offDeselecting of the scissor symbol, will disengage the stop sequence for manual cutting at the beginning

3.7 Delay of Start/Stop button has been reduced for embroideryDelay time reduced from 800ms to 200ms3.8 Thread breakage during jump stitches The tensi

Information on Software Update BERNINA 830 / 820Software Version 31 General Changes 3 1.1 Language “Finnish” integrated 3 1.2 Display of data vers

SOFTWARE VERSIONThe Release Note V29.39.00 is in addition to the Release Note V29.21.40 (6/2009).The newest firmware version for:Sewing machine Firm

2 SEWING UPDATES2.1 Thread tension for the underlay segments (buttonholes)To eliminate possible thread loops, the thread tension for segments with sho

2.3 The use of straight stitch feet with thread cuttingThe opening of the straight stitch foot is 0.4mm on both sides. The “tie on” stitch after cutti

In addition to the “automatic” mode, an extended manual mode is implemented. This mode gives the user the opportunity to start and stop the winding pr

2.9 Thread breakage hintIf the thread breaks, press the threading button to open the thread tension and remove the th-read. Rethread the normal way.2.

2.11 Presser Foot #0 can be used for automatic threading. With the “Walking foot” automatic threading is not possibleThe original help text mentioned

2.13 Pattern #169 improvedElongation limited to a maximum value of two for optimal results.2.14 Tension changed for the “tie on” stitchesTo improve th